BS 2709:2018 pdf download -Aerospace series – Aluminium alloy 2024- – T3510 – Bars and sections – 1,2 mm ≤ (a or D) ≤ 150 mm – With peripheral coarse grain control

BS 2709:2018 pdf download -Aerospace series – Aluminium alloy 2024- – T3510 – Bars and sections – 1,2 mm ≤ (a or D) ≤ 150 mm – With peripheral coarse grain control
This European Standard specifies the requirements relating to:
Aluminium alloy 2024-
T3510
Bars and sections
1,2 mm ≤ (a or D) ≤ 150 mm
With peripheral coarse grain control
for aerospace applications.
2 Normative references
The following documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited applies. For
undated references, the latest edition of the referenced document (including any amendments) applies.
EN 2004-1, Aerospace series — Test methods for aluminium and aluminium alloy products — Part 1: Determination of electrical conductivity of wrought aluminium alloy products
EN 2047, Aerospace series — Beaded L-section, extruded in aluminium alloys — Dimensions
EN 2048, Aerospace series — Extruded L-section, extruded in aluminium alloys — Dimensions
EN 2049, Aerospace series — Extruded channel section, extruded in aluminium alloys — Dimensions
EN 2050, Aerospace series — Extruded T-section, in aluminium alloys — Dimensions
EN 2070-1, Aerospace series — Aluminium and aluminium alloy wrought products — Technical specification — Part 1: General requirements
EN 2070-3, Aerospace series — Aluminium and aluminium alloy wrought products — Technical
specification — Part 3: Bar and section
EN 2134, Aerospace series — Round bars, extruded in aluminium and aluminium alloys, diameter 10 mm ≤ D ≤ 220 mm — Dimensions
EN 2341, Aerospace series — Aluminium and aluminium alloy — Square and rectangular extruded bars — Dimensions
1)
EN 4258, Aerospace series — Metallic materials — General organization of standardization — Links between types of EN standards and their use
EN 4500-2, Aerospace series — Metallic materials — Rules for drafting and presentation of material standards — Part 2: Specific rules for aluminium, aluminium alloys and magnesium alloys 1)
3 Terms and definitions
No terms and definitions are listed in this document.
ISO and IEC maintain terminological databases for use in standardization at the following addresses:
• IEC Electropedia: available at http://www.electropedia.org/
• ISO Online browsing platform: available at http://www.iso.org/obp
4 Requirements
See Table 1.BS 2709  download.