BS EN ISO 9013:2017 pdf download – Thermal cutting — Classification of thermal cuts — Geometrical product specification and quality tolerances (ISO 9013:2017)
This document presents geometrical product specifications and quality tolerances for the classification of thermal cuts in materials suitable for oxyfuel flame cutting, plasma cutting and laser cutting. It is applicable to flame cuts from 3 mm to 300 mm, plasma cuts from 0,5 mm to 150 mm and laser cuts from 0,5 mm to 32 mm. The geometrical product specifications are applicable if reference to this document is made in drawings or pertinent documents, e.g. delivery conditions. If this document were also to apply, by way of exception, to parts produced by other cutting processes, this would have to be agreed upon separately. Flatness defects are not addressed as such in this document. The references are to the current standards for the materials used.
2 Normative references
The following documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
ISO 1302:2002, Geometrical Product Specifications (GPS) — Indication of surface texture in technical product documentation
ISO 3274, Geometrical Product Specifications (GPS) — Surface texture: Profile method — Nominal characteristics of contact (stylus) instruments
ISO 4288, Geometrical Product Specifications (GPS) — Surface texture: Profile method — Rules and procedures for the assessment of surface texture
ISO 8015, Geometrical product specifications (GPS) — Fundamentals — Concepts, principles and rules
3 Terms and definitions
For the purposes of this document, the following terms and definitions apply.
ISO and IEC maintain terminological databases for use in standardization at the following addresses:
— IEC Electropedia: available at http:// www .electropedia .org/
— ISO Online browsing platform: available at http:// www .iso .org/ obp
operation of cutting the work piece
result of the cutting operation
3.2 Terms and definitions explained by figures
NOTE Figure 1 indicates the terms related to the cutting process of the work piece after the cutting process has started, Figure 2 indicates the terms for the finished work piece, Figure 3 shows a straight cut and Figure 4, a contour cut.BS EN ISO 9013 pdf download.