BS ISO 19632:2015 pdf download – Aerospace series — Fitting end, 24° internal cone, external thread, flareless type extra fine thread pitch inch series — Design standard
1 Scope
This International Standard specifies the dimensions, tolerances and the required characteristics of a fitting end, 24° cone, external thread, flareless type, size -04 up to -20 for use in hydraulic and fluid systems at 35 000 kPa (5 080 psi), diameter 6,35 mm ≤ D ≤ 31,75 mm (1/4 inch ≤ D ≤ 1 1/4 inch) for aerospace applications.
This is a design standard.
2 Normative references
The following documents, in whole or in part, are normatively referenced in this document and are indispensable for its application. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
ISO 3161, Aerospace — UNJ threads — General requirements and limit dimensions
3 Required characteristics — Configuration, dimensions and tolerances
The configuration, dimensions and tolerances shall conform with Figure 1 to Figure 5, Table 1 and Table 2.
Dimensions and tolerances are expressed in millimetres (inch).
Unless otherwise specified, the following tolerances are applicable:
— Linear dimensions: ± 0,25 mm (± 0.010 inch)
— Angular dimensions: ± 0°30’