BS ISO 9628:2019 pdf download – Rolling bearings — Insert bearings and eccentric locking collars — Geometrical product specifications (GPS) and tolerance values
This document specifies the dimensional and geometrical characteristics, boundary dimensions and tolerances of insert bearings and eccentric locking collars and the radial internal clearances of insert bearings.
2 Normative references
The following documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
ISO 1101, Geometrical product specifications (GPS) — Geometrical tolerancing — Tolerances of form,orientation, location and run-out
ISO 1132-1, Rolling bearings — Tolerances — Part 1: Terms and definitions
ISO 5593, Rolling bearings — Vocabulary
ISO 8015, Geometrical product specifications (GPS) — Fundamentals — Concepts, principles and rules
ISO 14405-1, Geometrical product specifications (GPS) — Dimensional tolerancing — Part 1: Linear sizes
3 Terms and definitions
For the purposes of this document, the terms and definitions given in ISO 1101, ISO 1132-1, ISO 5593 and ISO 14405-1 and the following apply.
ISO and IEC maintain terminological databases for use in standardization at the following addresses:
— ISO Online browsing platform: available at https: //www .iso .org/obp
— IEC Electropedia: available at http: //www .electropedia .org/
3.1
insert bearing
radial rolling bearing with a spherical outside surface and an extended inner ring with a locking device
Note 1 to entry: The locking device, used for fixing the inner ring to the shaft, may be an eccentric locking collar or set screws either in a concentric locking collar around the inner ring or directly in the inner ring.
4 Symbols
ISO 8015 shall be applied and the dimensional and geometrical characteristics shall be included in the technical product documentation (for example, on the drawing). The dimensional specifications associated to these characteristics are described in Table 1.
In this document, the ISO default specification operator for size is in accordance with ISO 14405-1, i.e. the two-point size is valid. NOTE Figures 1 to 6 are drawn schematically and sealing devices and cages are not shown in Figures 1 to 4. A tolerance value and width of tolerance zone associated to a characteristic is symbolised by t followed by the symbol for the characteristic, for example t Vdsp or t A1.BS ISO 9628 pdf download.