BS ISO 19724:2020 pdf download – Gasoline engines with direct injection — Cleanliness assessment of fuel injection equipment This document specifies cleanliness assessment procedures for evaluating the amount of debris presenton the clean side of the constituent parts of high-pressure gasoline direct fuel injection systems. Thepresence of such debris could lead to a reduction in the system’s operational performance. While other International Standards (e.g.IS0 16232) relate to the cleanliness of different types ofcomponents used in road vehicle fluid circuits, this document focuses on the special procedures appliedfor the components of gasoline direct fuel injection systems. 2Normative references The following documents are referred to in the text in such a way that some or all of their contentconstitutes requirements of this document.For dated references,only the edition cited applies.Forundated references,the latest edition of the referenced document (including any amendments) applies.ISO 3696,Water for analytical laboratory use — Specification and test methods ISO 14644-1,Cleanrooms and associated controlled environments —Part 1: Classification of air cleanlinessby particle concentration IS0 16232:2018,Road vehicles — Cleanliness of components and systems 3Terms and definitions For the purposes of this document, the terms and definitions given in ISO 16232 apply. ISO and IEC maintain terminological databases for use in standardization at the following addresses:-ISO online browsing platform: available at https://www.iso.org/obp —IEC Electropedia: available at http://www.electropedia.org/ 4 Procedures 4.1General All tests shall be carried out in a clean laboratory environment. Failure to achieve a satisfactory blanktest level of contamination could indicate unsuitable control of test conditions.Clean room conditionsaccording to IS0 14644-1, class 8, are recommended as a minimum for these procedures. The appropriate method to determine the required amount of fluid is by use of an extraction curve(declining test), as described in ISO 16232:2018,6.2.3.1 and B.1. In order to avoid each laboratoryfinding a different amount of fluid to be required, a guideline for the volume is given here for eachcomponent. The blank level tests described in IS0 16232:2018,6.3,are important procedures to check the quality ofthe laboratory equipment and shall be carried out once a week. Before starting the test procedure, the outer surface of the component or assembly shall be thoroughlycleaned by using a fluid like for the cleanliness assessment. This document covers the following components of the fuel injection equipment:- high pressure pump; 一 injector; 一 rail; 一 high pressure pipe;- high pressure sensor. 4.2General test conditions The following conditions are valid for all the components of the injection equipment.- Medium:...

Download Address

  • Download