BS ISO 22941:2021 pdf download – Rubber sheets for livestock — Dairy cattle — Specification This document specifies the characteristics of solid rubber sheets for dairy cattle. These sheets are used in a walking or lying area. This document does not include design of the product. 2 Normative references The following documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. ISO 37, Rubber, vulcanized or thermoplastic — Determination of tensile stress-strain properties ISO 48-4, Rubber, vulcanized or thermoplastic — Determination of hardness — Part 4: Indentation hardness by durometer method (Shore hardness) ISO 188:2011, Rubber, vulcanized or thermoplastic — Accelerated ageing and heat resistance tests ISO 815-1:2019, Rubber, vulcanized or thermoplastic — Determination of compression set — Part 1: At ambient or elevated temperatures ISO 1817, Rubber, vulcanized or thermoplastic — Determination of the effect of liquids ISO 3302-1, Rubber — Tolerances for products — Part 1: Dimensional tolerances ISO 4649:2017, Rubber, vulcanized or thermoplastic — Determination of abrasion resistance using a rotating cylindrical drum device ISO 5893, Rubber and plastics test equipment — Tensile, flexural and compression types (constant rate of traverse) — Specification 3 Terms and definitions For the purposes of this document, the following terms and definitions apply. ISO and IEC maintain terminology databases for use in standardization at the following addresses: — ISO Online browsing platform: available at https://www.iso.org/obp — IEC Electropedia: available at https://www.electropedia.org/ 3.1 walking area passage or area where cattle walk through in housing and stand for milking 3.2 lying area area where cattle rest in housing 4 Classification A rubber sheet is classified into two types depending on the application: — walking area; 6 Labelling The product label shall contain the following information: a) product name; b) product type: walking area or lying area; c) size: width, length and thickness; d) manufacturer’s or supplier’s identification; e) date of manufacture and/or manufacturer’s identifying lot number.BS ISO 22941 pdf download.
Download Address
Download