BS ISO 21780:2020 pdf download – Road vehicles — Supply voltage of 48 V — Electrical requirements and tests All 48 V components that are equipped with an interface for 12 V/24 V supply, or communication interfaces, shall also satisfy the corresponding requirements for the 12 V/24 V supply: — during the 12 V/24 V supply system tests, the voltage in the 48 V supply system is U 48N , unless required otherwise in the individual tests; — during the 48 V supply system tests, the voltage in the 12 V/24 V supply system is U N , unless indicated otherwise in the individual tests. All 48 V components that are equipped with an interface to any other supply voltage level shall also satisfy the corresponding standards. 8.8 Test procedure The test procedure shall be defined in conjunction with the customer and documented within a test plan. For each test, as applicable, the permitted error memory entries and the functional statuses for each function of the component shall be agreed with the customer and documented within the test plan. Details of the test setup, operating loads (e.g. triggering, original sensors, original actuators and replacement circuitry) and the required boundary conditions shall be agreed between the customer and the supplier and documented in a test plan and in the resultant test report. Components that are electrically both a source and a sink shall be tested in both modes of operation. The test equipment shall ensure that all interfaces which are required to meet the specified performance of the DUT are populated and functional to the required level. Signals or messages which shall be received from or transmitted to the vehicle controller in order to ensure the DUT functions as expected may be simulated if a full vehicle or HIL simulation is not used. In all cases, program and data storage devices shall remain in FS1 until the component is deactivated. If the device has non-volatile memory, the integrity (not the current status) of the non-volatile memory shall be ensured at all times. Damage to the DUT is not permitted in FS1 to FS4. The permissible limit values specified in the data sheets (e.g. electrical, thermal or mechanical) of the electric/electronic components in the DUT shall not be exceeded. Evidence of this is provided at least by the parameter check as described in 8.9. An electrical test begins when the DUT has...
Download Address
Download