BS ISO 19709-1:2016 pdf download – Transport packaging — Small load container systems Part 1: Common requirements and test methods 1 scope This document specifies the essential characteristics and the common requirements and test methodsfor SLCsystems used in the handling,transport and storage for the automotive industry.The applicationof such systems is described in Annex B. These containers are based on the modular area 600 mm x 400 mm, 550 mm x 366 mm and600 mm x 500 mm and subdivisions according to ISO 3394 and IS03676. This document is designed to be read in conjunction with the particular part which specifies thechosen system. 2Normative references The following documents are referred to in the text in such a way that some or all of their contentconstitutes requirements of this document. For dated references,only the edition cited applies.Forundated references, the latest edition of the referenced document (including any amendments) applies.ISO 2234,Packaging — Complete, filled transport packages and unit loads – Stacking tests using astatic load ISO 2248,Packaging —Complete, filled transport packages —Vertical impact test by droppingIS0 3676, Packaging —Complete, filled transport packages and unit loads —Unit load dimensions IEC 61340-2-3,Electrostatics — Part 2-3:Methods of test for determining the resistance and resistivity ofsolid materials used to avoid electrostatic charge accumulation 3Terms and definitions For the purposes of this document, the terms and definitions given in ISO 21067,ISO/TS 19709-2,ISO/Ts 19709-3 and the following apply. ISO and lEC maintain terminological databases for use in standardization at the following addresses:一IEC Electropedia: available at http://www.electropedia.org/ -ISO Online browsing platform: available at http://www.iso.org/obp 3.1 ends two shortest vertical walls of an SLC (3.5) 3.2 nominal load recommended maximum mass of container contents, lowest safe load value for the specified support conditions, independent of the type of load (excluding concentrated loads) [SOURCE: ISO 445:2013, 2.2, modified, “recommended maximum mass of container contents” added, Note 1 and Note 2 removed.] 3.3 nominal stacking load recommended maximum mass applied to the top of the lowest SLC (3.5) in a stack 3.4 sides two longest vertical walls of an SLC (3.5) 3.5 small load container SLC open-topped durable, reusable, rigid, rectangular modular container which can be handled manually and/or mechanically and is the central element of a SLC system 3.6 system entity consisting of interdependent components [SOURCE: ISO 3676:2012, 3.2] 4 Module capacity These SLC systems are based on the area module 600 mm × 400 mm according to ISO 3394. They shall...

Download Address

  • Download