BS 10029:2010 pdf download – Hot-rolled steel plates 3 mm thick or above — Tolerances on dimensions and shape

BS 10029:2010 pdf download – Hot-rolled steel plates 3 mm thick or above — Tolerances on dimensions and shape This European Standard specifies tolerances on dimensions and shape for hot-rolled non-alloy and alloy steel plates with the following characteristics: a) Nominal thickness: 3 mm ≤ t ≤ 400 mm; b) Nominal width: w ≥ 600 mm. Tolerances for products of width w < 600 mm cut or slit from plate should be agreed between manufacturer and purchaser at the time of enquiry and order. This European Standard applies, but is not limited, to steel grades defined in EN 10025-2 to EN 10025-6:2004+A1:2009, EN 10028-2 to EN 10028-6, EN 10083-2 and EN 10083-3, EN 10084, EN 10085,EN 10149-2 and EN 10149-3, EN 10207 and EN 10225 (see also Annex A). It does not apply to stainless steels. This European Standard does not include round plates, custom-made plates, chequer or bulb plate for flooring and wide flats. 2 Normative references The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. EN 10079, Definition of steel products EN 10163-1, Delivery requirements for surface condition of hot-rolled steel plates, wide flats and sections — Part 1: General requirements EN 10163-2, Delivery requirements for surface conditions of hot-rolled steel plates, wide flats and sections — Part 2: Plate and wide flats 3 Terms and definitions For the purposes of this document, the following term and definition apply. 3.1 plate see EN 10079 4 Information to be supplied by the purchaser 4.1 Mandatory information The following information shall be supplied by the purchaser at the time of enquiry and order: a) quantity to be delivered; b) designation of the product form (plate); c) number of this dimensional standard (EN 10029); d) nominal thickness in millimetres; e) nominal width in millimetres; f) nominal length in millimetres. Plates ordered according to this European standard shall be delivered as follows:  tolerance class A for thickness unless otherwise stated (see 6.1, Table 1);  trimmed edges;  normal edge camber and out-of-squareness (see 7.1);  normal tolerances for flatness, class N (see 7.2, Table 4). If no information concerning points a) to f) of 4.1 is given by the purchaser, the supplier shall refer back to the purchaser. 4.2 Options A number of options are...