BS EN 4710-03:2015 pdf download – Aerospace series — Quick release fastening systems for non-structural applications Part 03: Spring clamp

BS EN 4710-03:2015 pdf download – Aerospace series — Quick release fastening systems for non-structural applications Part 03: Spring clamp The applicable temperature range is —55 Cto 85 C. 2Normative references The following documents,in whole or in part, are normatively referenced in this document and areindispensable for its application. For dated references,only the edition cited applies. For undatedreferences, the latest edition of the referenced document (including any amendments) applies. EN 2424,Aerospace series — Marking of aerospace products EN 2516,Aerospace series—Passivationof corrosion resistant steels and decontamination of nickel basealloys EN4710-01,Aerospace series—Quickrelease fastening systemsfor non-structuralapplications —Part 01:Technical specification EN4710-02,Aerospace series—Quickrelease fastening systemsfor non-structuralapplications —Part 02:Stud spring clamp family EN4710-06,Aerospace series —Quickrelease fastening systems fornon-structuralapplications —Part 06:stud – quick-release and locking EN4710-07,Aerospace series—Quickrelease fastening systemsfor non-structuralapplications —Part 07:Retaining grommet EN 10151, Stainless steel strip for springs — Technical delivery conditions EN 10132-4,Cold-rolled narrow steel strip for heat-treatment—Technical delivery conditions —Part 4:Spring steels and other applications ISO 2768-1:1989, General tolerances — Part 1:Tolerances for linear and angular dimensions withoutindividual tolerance indications ISO 2768-2:1989,General tolerances – Part 2: Geometrical tolerances for features without individualtolerance indications DIN 50979,Metallic coatings — Electroplated coatings of zinc and zinc alloys on iron or steel withsupplementary Cr(Vl)-free treatment 3Requirements 3.1Configuration, dimensions, tolerances and mass The configuration，dimensions,tolerances and mass shall conform with Figure 1 and Table 1.Tolerances not specified, shall be in accordance with ISO 2768-mK (IS0 2768-1:1989 and ISo 2768-2:1989). Dimensions are unless otherwise specified per manufacturer’s option.