BS ISO 16792:2015 pdf download – Technical product documentation — Digital product definition data practices This International Standard specifies requirements for the preparation, revision, and presentation ofdigital product definition data, hereafter referred to as data sets.Itsupports two methods of application:;model-only and model and drawing in digital format. Its structure presents requirements common toboth methods followed by clauses providing for any essential, differing requirements for each method.Additionally, its use in conjunction with computer-aided design (CAD) systems could assist in theprogression towards improved modelling and annotation practices for CAD and engineering disciplines,as well as serving as a guideline for IT engineers. The aspects specified in this International Standard refer mainly, but not exclusively, to requirementsthat differ or are additional to those provided in existing,related standards.Where nosuch requirementsare identified, it is safe to assume that the appropriate existing ISO standards are instead applicable. 2Normative references The following referenced documents are indispensable for the application of this document. For datedreferences, only the edition cited applies. For undated references, the latest edition of the referenceddocument (including any amendments) applies. ISo 128 (all parts), Technical drawings — General principles of presentation ISO 129-1:2004,Technical drawings—Indication of dimensions and tolerances —Part 1:General principlesISO 286(all parts),Geometrical product specifications (GPS)— ISo code system for tolerances on linear sizesIS0 1101:2012,Geometrical product specifications (GPS)—Geometrical tolerancing —Tolerances of form,orientation, location and run-out ISO 1302,Geometrical Product Specifications (GPS)- Indication of surface texture in technical productdocumentation ISO 2553,Welding and allied processes —Symbolic representation on drawings —Welded jointsISO 3098-1:2015,Technical product documentation —Lettering —Part 1:General requirements ISO 3098-5:1997,Technical product documentation — Lettering — Part 5: CAD lettering of the Latinalphabet, numerals and marks ISO 5456(all parts), Technical drawings – Projection methods ISO 5457:1999,Technical product documentation —Sizes and layout of drawing sheets ISO 5459:2011,Geometrical product specifications (GPS) — Geometrical tolerancing — Datums anddatum systems ISo 7200:2004, Technical product documentation — Data fields in title blocks and document headersISO 10209:2012,Technical product documentation —Vocabulary —Terms relating to technical drawings,product definition and related documentation ISO 11442:2006,Technical product documentation — Document management ISO 14405-1,Geometrical product specifications (GPS) – Dimensional tolerancing – Part 1: Linear sizes 3Terms and definitions For the purposes of this document, the terms and definitions in ISo 10209:2012 and the following apply.3.1General 3.1.1 absolute coordinate system primary model coordinate system in the CAD model used to define the location of digital elements inthe CAD model 3.1.2 datum system set of two or more situation features established in a specific...
Download Address
Download