BS 6056:2019 pdf download – Aerospace series – Rod-end with bearing per EN 4614 with self lubricating liner in corrosion resisting steel with external threaded shank – Dimensions and loads – Inch series This European standard specifies the characteristics of adjustable rod-ends consisting of: a self-aligning ball bearing with self-lubricating liner (EN 4614); a rod-end with threaded shank with an optional longitudinal groove for locking purposes. They are intended for use in fixed or moving parts of the aircraft structure and their control mechanisms. 2 Normative references The following documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. EN 2068, Aerospace series — Rod ends with self-lubricating, self-aligning bearings — Technical specification EN 2133, Aerospace series — Cadmium plating of steels with specified tensile strength ≤ 1 450 MPa,copper, copper alloys and nickel alloys EN 2424, Aerospace series — Marking of aerospace products EN 4614, Aerospace series — Spherical plain bearing in corrosion resisting steel with self-lubricating liner,wide series — Dimensions and loads — Inch series ISO 1132-1, Rolling bearings — Tolerances — Part 1: Terms and definitions ISO 3161, Aerospace — UNJ threads — General requirements and limit dimensions ISO 3353-1, Aerospace — Lead and runout threads — Part 1: Rolled external threads ISO 3353-2, Aerospace — Lead and runout threads — Part 2: Internal threads ISO 8074, Aerospace — Surface treatment of austenitic stainless steel parts NAS 559, Lock-rod end (key type) 1 SAE AMS 5643, Steel, corrosion resistant, bars wire, forgings, tubing and rings 16Cr-4.0Ni-0.30(Cb+Ta)-4.0Cu solution heat treated, precipitation hardenable TR 4475, Bearings and mechanical transmissions for airframe applications — Vocabulary 2 3 Terms, definitions and symbols For the purposes of this document, the terms and definitions given in TR 4475 apply. ISO and IEC maintain terminological databases for use in standardization at the following addresses: ISO Online browsing platform: available at http://www.iso.org/obp IEC Electropedia: available at http://www.electropedia.org/ Symbols of limit deviations are in accordance with definitions of ISO 1132-1. α maximum angle of tilt of the outer ring with respect to the inner ring, with the spherical surface of the outer ring being completely in contact with the inner ring C p push out load C s permissible static radial...

Download Address

  • Download