BS ISO 16237:2015 pdf download – Mechanical joining — Destructive testing of joints — Specimen dimensions and test procedure for cross-tension testing of single joints

BS ISO 16237:2015 pdf download – Mechanical joining — Destructive testing of joints — Specimen dimensions and test procedure for cross-tension testing of single joints This International Standard specifies the geometry of the test specimens and the method for the cross-tension testing of single mechanical joints on single-lap test specimens up to a single sheet thickness of4,5 mm. The term “sheet”, as used in this International Standard, includes extrusions and cast materials. The purpose of the cross-tension test is to determine the mechanical characteristics and the failuretypes of the joints made with different joining methods. This International Standard does not apply to civil engineering applications such as metal building andsteel construction which are covered by other applicable standards. 2Normative references The following documents, in whole or in part, are normatively referenced in this document and areindispensable for its application. For dated references,only the edition cited applies.For undatedreferences, the latest edition of the referenced document (including any amendments) applies. ISO 2768-1,General tolerances — Part 1: Tolerances for linear and angular dimensions without individualtolerance indications ISO 7500-1，Metallic materials — Verification of static uniaxial testing machines — Part 1: Tension/compression testing machines —Verification and calibration of the force-measuring system 3 Terms and definitions For the purposes of this document, the following terms and definitions apply. 3.1 cross-tension strengthcTS Fmax maximum force, recorded in the test 3.2 cross-tension forceF force, recorded in the test 3.3 crosshead displacement displacement of the crosshead of the test equipment during the cross-tension test3.4 crosshead displacement at maximum forceSFmax displacement at which the maximum force Fmax is recorded