BS 2709:2018 pdf download -Aerospace series – Aluminium alloy 2024- – T3510 – Bars and sections – 1,2 mm ≤ (a or D) ≤ 150 mm – With peripheral coarse grain control

BS 2709:2018 pdf download -Aerospace series – Aluminium alloy 2024- – T3510 – Bars and sections – 1,2 mm ≤ (a or D) ≤ 150 mm – With peripheral coarse grain control This European Standard specifies the requirements relating to: Aluminium alloy 2024- T3510 Bars and sections 1,2 mm ≤ (a or D) ≤ 150 mm With peripheral coarse grain control for aerospace applications. 2 Normative references The following documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. EN 2004-1, Aerospace series — Test methods for aluminium and aluminium alloy products — Part 1: Determination of electrical conductivity of wrought aluminium alloy products EN 2047, Aerospace series — Beaded L-section, extruded in aluminium alloys — Dimensions EN 2048, Aerospace series — Extruded L-section, extruded in aluminium alloys — Dimensions EN 2049, Aerospace series — Extruded channel section, extruded in aluminium alloys — Dimensions EN 2050, Aerospace series — Extruded T-section, in aluminium alloys — Dimensions EN 2070-1, Aerospace series — Aluminium and aluminium alloy wrought products — Technical specification — Part 1: General requirements EN 2070-3, Aerospace series — Aluminium and aluminium alloy wrought products — Technical specification — Part 3: Bar and section EN 2134, Aerospace series — Round bars, extruded in aluminium and aluminium alloys, diameter 10 mm ≤ D ≤ 220 mm — Dimensions EN 2341, Aerospace series — Aluminium and aluminium alloy — Square and rectangular extruded bars — Dimensions 1) EN 4258, Aerospace series — Metallic materials — General organization of standardization — Links between types of EN standards and their use EN 4500-2, Aerospace series — Metallic materials — Rules for drafting and presentation of material standards — Part 2: Specific rules for aluminium, aluminium alloys and magnesium alloys 1) 3 Terms and definitions No terms and definitions are listed in this document. ISO and IEC maintain terminological databases for use in standardization at the following addresses: • IEC Electropedia: available at http://www.electropedia.org/ • ISO Online browsing platform: available at http://www.iso.org/obp 4 Requirements See Table 1.BS 2709  download.